Sony CA-950 Bedienungsanleitung Seite 26

Location and Function of Parts and Controls
q lSERIAL OUT (serial digital video signal output)
connector (BNC type)
Outputs a component serial digital signal input to the
AUX IN connector of the CCU.
In the case of dual camera link, connect to the SERIAL
IN connector of the secondary CA-950/950P.
When using the camera as stand alone, camera image
signal is output from this connector.
When the BVP-9500WS/9500WSP is connected with
the Camera Adaptor and the system is under super
motion (third times normal speed), this connector
cannot be used.
w; DC OUT (direct current output) connector
(4-pin)
Outputs a direct current of 10.5 V to 17 V at a
maximum rated current output of 500 mA. Connecting
equipment with a power consumption greater than the
maximum rating will activate the protection circuit,
cutting off the current flow.
wa PGM (program) level control (for the CA-950P)
Adjusts the audio volume of the program.
ws ENG (engineer) level control (for the CA-950P)
Adjusts the audio volume of the engineer.
wd MIC LINE switch (for the CA-950P)
PROD: Selects a microphone on the producer's line.
OFF: Turns off the microphone.
ENG: Selects a microphone on the engineer's line.
wf PROD (producer) level control (for the
CA-950P)
Adjusts the audio volume of the producer.
wg TRACKER level control (for the CA-950P)
Adjusts the audio volume of the tracker.
wh LEVEL (intercom level) switch
(for the CA-950P)
REAR: Adjust the intercom reception level with the
PGM level control, ENG level control, PROD
level control, or TRAKER level control.
FRONT: Use the control on the camera to adjust the
intercom reception level.
8(E)