Intended Use; Device Elements; Before Start-Up - Würth ESF 500-E Universal Originalbetriebsanleitung

Intended use

The machine is intended for grinding and polish-
ing metal, plastic or wood using sanding belts,
non-woven belts, high-performance ceramic belts or
compacted fibre belts, without the use of water. The
machine is designed exclusively for 2-hand use.
Use only original Würth accessories. Any other use
or use beyond this scope is considered improper
use.
The user is responsible for damage result-
ing from improper use.

Device elements

Overview [fig. I]
1 Contact arm for abrasive belts
2 Protective tube
3 Protective cover
4 Bayonet locking bolt
5 Attachment (main piece)
6 Locking bolt
7 Adapter ring
8 Drive roller
9 Clamping lever
Assembly
▸
Place the appropriate adapter ring [7] on the
electric grinding files.
▸
Place the attachment [5] over the electric grinding
files using the adapter ring.
Make sure that the attachment lies flat on
the electric grinding file!
▸
Turn clamping lever [9] upwards until it is in
vertical position.
▸
Twist the drive roller [8] onto the threaded spindle
of the electric grinding files and tighten it by hand.
▸
Insert the contact arm [1] into the front hole of the
main piece [5]. Let the cut-out at the end of the
arm point upwards.
▸
Fix the contact arm [1] turning it 90° to the right.
16
▸
Push the contact arm [1] to the rear to tension the
drive belt or abrasive belt.
Adjust the abrasive belt precisely to the
guide rollers and slide it on the drive
roller [8] until it is in central position!
▸
Slide the protective tube [2] over the attach-
ment [5] and the contact arm until the locking tab
engages in the locking bolt [6] or rests against
the protective cover [3].
▸
Abrasive belts with a width of 6 - 15 mm and
a length of 520 mm, 533 mm, 610 mm and
650 mm can be used.

Before start-up

▸
Check the mains voltage of the electric file. The
mains voltage must conform with the voltage
specified on the type plate.
▸
Check the abrasive belt prior to use. The drive
roller must be mounted centrically and positioned
at the stop. The maximum permissible speed of
the abrasive belt must never be exceeded. Adhere
to nation-specific regulations. Take protective mea-
sures if harmful, combustible or explosive dusts
may be produced during work.
▸
Wear a dust protection mask and, if connectable,
use a saw dust/chip extractor.
▸
Do not use accessories which are not spe-
cifically designed and recommended by
the tool manufacturer for this electrical
tool. Just because an accessory can be attached
to your power tool does not mean safe operation
is guaranteed.