Tool Specifications; Machine Elements; Intended Use - Würth 0702 445 Serie Originalbetriebsanleitung

EWS 24.book Seite 17 Dienstag, 29. Oktober 2019 10:09 10
Angle Grinder
Article number
Rated power input
Output power
No-load speed
Grinding disc dia., max.
Max. permitted thickness of the cut-off or
grinding disc
Max. permitted thickness of the application tool
in the clamping range when using clamping
nut 15
Max. permitted thickness of the application tool
in the clamping range when using clamping
nut 14
Grinder spindle length
Grinder spindle thread
Weight according to EPTA-Procedure 01
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries, these values
can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.

Machine Elements

1 Spindle lock button
2 Locking lever for protection guard
3 Grinder spindle
4 On/Off switch
5 Safety switch against starting/lock-on*
6 Release button for turning handle
7 Auxiliary handle
8 Protection guard for grinding/roughing
9 Protection guard for cutting
10 Hand guard
11 Wire brush
12 Mounting flange*
13 Grinding/cutting disc**
14 Quick-clamping nut*
15 Clamping nut*
16 Two-pin spanner for clamping nut*
17 Screw (for adjusting the tensioning force of the
clamp)
18 Electronics malfunction indicator (LED)
*Depending on version
**Not all of the accessories illustrated or described are
included as standard delivery.

Tool Specifications

EWS 24-180
EWS 24-180-S
0702 445 X
[W] 2400
[W] 1600
-1
[min ] 8500
[mm] 180
[mm] 8
[mm] 14
[mm] 10
[mm] 25
[mm] 14
[kg] 5.7
/ II
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is required.
The protection guard is not approved for all grinding
accessories.
For damage caused by usage other then intended,
the user is responsible.
Mounting the Protective Devices
Disconnect the mains plug from electric supply.
Protective Guard (see figure
When working with grinding discs, a special
protection guard 8 must be mounted.
For work with cut-off discs, a special protection
guard for cutting 9 must be mounted.
EWS 24-230 SWS 26-230-T
EWS 24-230-S
EWS 24-230-T
0702 446 X 5707 090 X
2400 2600
1600 1800
6600 6600
230 230
8 8
14 10
10 8
25 19
14 14
5.8 6.6
/ II / II

Intended Use

)
C
17