Troubleshooting; Overload Protection; Warranty - Würth EBS 125-E Originalbetriebsanleitung

Troubleshooting

Overload protection

• The load speed drops.
— The coil temperature is too high!
▸
Allow the machine to run at idle speed until it has
cooled down.
• Starting operations cause transient drops in
voltage.
— Under unfavourable network conditions, other
devices may be affected.
— No faults are to be expected with network imped-
ances below 0.4 Ohm.
Restarting protection
• Machine not running.
— The restart protection device has tripped. If the
mains plug is inserted with the machine switched
on, or if the power supply is restored after an
interruption, the machine does not start.
▸
Switch the machine off and on again.
Accessories and spare parts
If in spite of careful manufacturing and test proce-
dures, the device becomes faulty, a repair by Würth
masterService should be arranged.
With any enquiries or spare parts orders, always
quote the article number as given on the device type
plate.
The latest spare parts list for the device is available
online at http://www.wuerth.com/partsmanager.
Alternatively, contact your local Würth agency for a
hardcopy.
Disposal
Electrical power tools, accessories and
packaging should be sorted and
submitted to an environmentally-sound
recycling facility. Only for EU countries:
Do not dispose of your electrical power
tool in household waste. According to European
Directive 2012/19/EU on waste electrical and
electronic equipment and its implementation in
national law, broken and unserviceable electric
power tools must be collected separately and
submitted to an environmentally sound recycling
facility.
20

Warranty

We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note). Damage that has
occurred will be corrected either by replacement or
by repair. Damage caused by improper handling is
not covered by the warranty. Claims under warranty
can only be accepted if the device is returned fully
assembled to a Würth agency, your Würth sales rep-
resentative or an authorised Würth customer service
workshop. Subject to technical changes without prior
notice. We accept no liability for printing errors.
EC Declaration of Conformity
We declare under our sole responsibility that this
product conforms to the following standards and
directives:
Standards
• EN 60745-1:2009 + A11:2010
• EN 60745-2-3:2011 + A2:2013 +
A11:2014 + A12:2014
• EN 50581:2012
in accordance with the regulations stipulated in the
directives:
EC Directive
• 2006/42/EC
• 2014/30/EU
• 2011/65/EU
Technical documentation at:
Adolf Würth GmbH & Co. KG, Abt. PPT
Reinhold-Würth-Straße 12 – 17,
74653 Künzelsau, GERMANY
F. Wolpert
Head of Product Man-
agement,
Authorised Signatory
Künzelsau: 03.04.2017
Dr.-Ing. S. Beichter
Head of Quality,
Authorised Signatory