Kenwood FPM250 series Bedienungsanleitungen Seite 7

slicing/grating discs
G
Never remove the lid until the cutting disc has completely stopped.
G
Handle the cutting discs with care - they are extremely sharp
centrifugal juicer
G
Do not use the juicer if the filter is damaged.
G
The cutting blades on the base of the filter drum are very sharp, take care
when handling and cleaning the drum.
G
Only use the pusher supplied. Never put your fingers in the feed tube.
Unplug before unblocking the feed tube.
G
Before removing the lid, switch off and wait for the filter to stop.
before plugging in
G
Make sure your electricity supply is the same as the one
shown on the underside of your appliance.
WARNING: THIS APPLIANCE MUST BE EARTHED.
G
This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no.
1935/2004 of 27/10/2004 on materials intended for contact
with food.
before using for the first time
1 Remove the plastic blade covers from the knife blade. Take
care the blades are very sharp. These covers should
be discarded as they are to protect the blade during
manufacture and transit only.
2 Wash the parts see 'care & cleaning'
key
processor
pusher
feed tube
lid
detachable drive shaft
bowl with drive shaft
power unit
speed/pulse control
safety interlocks
cord storage (at back)
A
plastic liquidiser
blade unit
sealing ring
goblet
filler cap
lid
B
glass liquidiser
blade unit
sealing ring
goblet
lid
filler cap
attachments
Not all of the attachments listed below may be included with
your food processor. Attachments are dependent upon the
model variant.
glass multi mill (if supplied)
knife blade
dough tool
twin beater geared metal whisk
thick slicing/coarse grating disc
thin slicing/fine grating disc
rasping/parmesan disc (if supplied)
citrus juicer (if supplied)
centrifugal juicer (if supplied)
spatula (if supplied)
to use your food processor
1 Fit the bowl by aligning the
the power unit, turn clockwise
2 Fit an attachment over the bowl drive shaft.
Note: Detachable drive shaft
fitted when using the discs, citrus juicer or twin
beater geared metal whisk.
G
Always fit the bowl and attachment onto the processor
before adding ingredients.
3 Fit the lid - ensuring the top of the drive shaft/tool locates
into the centre of the lid.
G
Do not use the lid to operate the processor,
always use the on/off speed control.
4 Plug in, switch on and select a speed. (Refer to the
recommended speed chart).
G
The processor will not operate if the bowl or lid
are not fitted correctly into the interlock. Check
that the feed tube and bowl handle are situated
to the right hand side.
G
Use the pulse (P) for short bursts. The pulse will operate for
as long as the control is held in position.
5 Reverse the above procedure to remove the lid, attachments
and bowl.
G
Always switch off and unplug before removing the
lid.
important
G
Your processor is not suitable for crushing or grinding coffee
beans, or converting granulated sugar to caster sugar.
4
on the bowl with the on
until it locks .
should only be