Kenwood FPM250 series Bedienungsanleitungen Seite 10

slicing/grating discs
To use the discs.
reversible slicing/grating discs - thick
Use the grating side for cheese, carrots, potatoes and foods
of a similar texture.
Use the slicing side for cheese, carrots, potatoes, cabbage,
cucumber, courgette, beetroot and onions.
rasping disc (if supplied)
Grates Parmesan cheese and potatoes for German potato
dumplings.
to use the cutting discs
1 Fit the bowl onto the power unit, add the detachable drive
shaft.
2 Holding by the centre grip, place the disc onto the drive shaft
with the appropriate side uppermost.
3 Fit the lid.
4 Put the food in the feed tube.
5 Switch on and push down evenly with the pusher - never
put your fingers in the feed tube.
hints
G
Use fresh ingredients
G
Don't cut food too small. Fill the width of the feed tube fairly
full. This prevents the food from slipping sideways during
processing.
G
Food placed upright comes out shorter than food placed
horizontal.
G
There will always be a small amount of waste on the disc or
in the bowl after processing.
citrus juicer
(if supplied)
Use the citrus juicer to squeeze the juice from citrus fruits (eg
oranges, lemons, limes and grapefruits).
cone
sieve
to use the citrus juicer
1 Fit the bowl onto the power unit, add the detachable drive
shaft.
2 Fit the sieve into the bowl - ensuring the sieve handle is
locked into position directly over the bowl handle.
3 Place the cone over the drive shaft turning until it drops all
the way down.
4 Cut the fruit in half. Then switch on and press the fruit onto
the cone.
G
The citrus juicer will not operate if the sieve is
not locked correctly.
G
For best results store and juice the fruit at room temperature
and hand roll on a worktop before juicing.
G
To help with juice extraction move the fruit from side to side
when juicing.
G
When juicing large quantities, empty the strainer regularly to
prevent the build up of pulp and seeds.
centrifugal juicer
Use the centrifugal juicer for making juice from firm fruit
and vegetables.
, thin
pusher
centrifugal lid
pulp remover
filter drum
bowl
juicing spout
to use the centrifugal juicer
1 Place the juicer bowl with the spout
align the
turn clockwise ¸ until it locks
2 Place the pulp remover
the tabs locate with the slots in the bottom of the drum ¹
3 Fit the filter drum
4 Place the attachment lid
locks
lid are not fitted correctly into the interlock
5 Place a suitable glass or jug under the juice outlet.
6 Cut the food to fit the feed tube.
7 Switch on and push down evenly with the pusher - never
put your fingers in the feed tube. Process fully before
adding more.
G
After adding the last piece, let the juicer run for a further 30
seconds to extract all the juice from the filter drum.
important
G
f the juicer starts to vibrate, switch off and empty the pulp
I
from the drum. (The juicer vibrates if the pulp becomes
unevenly distributed).
G
Maximum capacity that can be processed at one time is
800g of fruit or vegetables.
G
Some very hard foods may make your juicer slow down or
stop. If this happens switch off and unblock the filter.
G
Switch off and clear the pulp collector regularly during use.
hints
G
Before processing remove stones and pips (eg pepper,
melon, plum) and tough skins (eg melon, pineapple). You
don't need to peel or core apples and pears.
G
Use firm, fresh fruit and vegetables.
G
Citrus fruit - peel and remove the white pith, otherwise the
juice may taste bitter. For best results use the citrus juicer.
7
(if supplied)
on the bowl with the
.
into the filter drum
.
onto the bowl and turn until it
. Your juicer will not operate if the bowl or
onto the power unit,
on the power unit and
- ensuring
.
.