Maintenance; Cleaning The Hood; Cleaning The Grease Filters; Replacing The Charcoal Filters - Indesit H562 IX Betriebsanleitung

Maintenance

! Always switch off the electricity supply before
carrying out any cleaning or servicing operations
on the appliance.
! To avoid possible risks of fire always comply with
the indicated instructions when cleaning grease
filters and when removing grease deposits from
the appliance.
Careful maintenance will assure good functioning and
good efficiency over time.

Cleaning the hood

Any fat deposits should be removed from the
appliance periodically depending on amount of use (at
least every 2 months). Avoid using abrasive or
corrosive products. To clean painted appliances on
the outside, use a cloth dipped in lukewarm water and
neutral detergent. To clean steel, copper or brass
appliances on the outside, it is always best to use
specific products, following the instructions on the
products themselves. To clean the inside of the
appliance, use a cloth (or brush) dipped in denatured
ethyl alcohol.

Cleaning the grease filters

To remove the grease filters, push the catch near the
handle towards the inside and pull the filter
downwards.
Wash the filters by hand or in the dishwasher using
a neutral detergent. If they are washed
in the dishwasher, any loss of colour will
not jeopardise functioning of the filters in any way.
Clean the grease filters every 2 months on average
depending on how heavily the hood is used.

Replacing the charcoal filters

If using the hood in the filtering version, the charcoal
filters (L) will periodically have to be replaced.
Remove the charcoal filters by turning it clockwise.
L
Replace the charcoal filters on average every 6
months depending on how heavily the hood is used.

Replacing the lamps

Pay particular ATTENTION when carrying out this
operation and remember to remove the voltage.
After having removed the grease filters, remove
the light fitting, operating manually from inside
the hood.
Apply light pressure to the mobile part of the 2
retainers and release it from the outside.
Unscrew the bulb and replace it with a bulb
of the same type.
Re-assemble the light fitting by pushing it into its
seat from the outside.
GB
15