Bartscher 110 Serie Bedienungsanleitung Seite 40

- light the main burner, positioning the knob in one of the eight possible positions, choosing the
one most suited to the type of cooking desired, considering that they correspond indicatively to
the temperatures shown below:
Position (N°)
Température (°C)
To put out the main burner, it is necessary to turn the knob to the right into the on position
put out also the pilot, turn the knob again into the off position
Electric fry-top (fig. 12 – pag.5)
To light the fry-top, proceed in the following way:
- Turn the knob (1) of the thermostat into the position which corresponds to the cooking
temperature desired; the two lights come on, the green light stays on all the time to show that
there is tension, whilst the orange one goes off as soon as the hotplates reach the desired
temperature.
To turn off the hotplate turn the knob into the 0 position.
ATTENTION! Only use the appliance under surveillance. Never let the hotplates function
with nothing on them.
Abnormal functioning
If for any reason, the appliance does not start up or stops working during use, check that the
energy supply and the control knobs are set correctly; if all is regular, call customer service.
CARE AND MAINTENANCE OF THE APPLIANCE
Cleaning
ATTENTION! Before doing any cleaning, make sure that the appliance is disconnected from
the electric mains and that the gas cutoff valve is closed. During cleaning operations, avoid
using direct or high pressure sprays of water on the appliance. Cleaning must be done when
the appliance is cold.
The parts in steel can be cleaned with warm water and neutral detergent, using a cloth; the detergent
must be suitable for cleaning stainless steel and must not contain abrasive or corrosive substances.
Do not use common steel wool or anything similar which, depositing iron particles, could cause rust
from it. It is also better to avoid using sandpaper or emery paper. Only in the event of encrusted
dirt, pumice stone in powder may be used but an abrasive synthetic sponge or stainless steel wool
would be preferable, to be used in the direction of the grain. After washing, dry with a soft cloth.
If the appliance is out of use for a long time, it is advisable to turn off the gas tap. Then disconnect
the main electricity supply and wipe all stainless steel surfaces with a cloth soaked in vaseline oil in
order to give it a protective film and air the rooms now and again.
1 2
110 150
Pag. 39/66
3 4
190 230
.
Q
5 6
270 310
7
350
, to