cecotec Conga 3090 series Bedienungsanleitung Seite 24

ENGLISH
4.1. ROBOT BUTTONS
1. AUTO mode
Press on the robot for it to start cleaning automatically in zig-zag, recognizing which
areas it has cleaned and which ones it has not.
The robot will plan the cleaning route automatically as it is cleaning. If during this mode
the robot is directed manually, it will re-plan the route and could repeat already-cleaned
areas. In order to ensure efficient cleaning, do not operate it manually during auto mode
cleaning.
If the battery is low during the cleaning cycle, the robot will smartly return to the charging
base automatically and, once it is fully charged, it will resume the cleaning from the same
point, offering a high-efficiency cleaning.
During the cleaning, the robot will make a brief stop to evaluate the area and plan the
cleaning route (this stop will vary depending on the house conditions).
2. SPOT cleaning
While the robot is paused or in standby mode, press the LASER
button to activate Spot-cleaning mode. The robot will clean
within a 2*2 space, and will return to the starting position once it
has finished. This mode is commonly used to clean floors
3. Back-home mode
Press the HOME button on the robot in order to send the robot to the charging base. This
mode can activated during any other cleaning cycle and the robot will automatically
return to the charging base and stop the cleaning process.
The robot will take the shortest route back to the charging base thanks to its map
memorizing and the smart back-home function.
When a cleaning cycle has been completed or the robot's battery is low, the robot will
also return to the charging base to avoid running out of battery.
Warning: remove the water tank during charge.
24
3
1
2