Rear Panel; Maintenance; Optionals - CEMONT SMARTY TX160 ALU Betriebs-Wartungs Und Sicherheitsanleitung

GB
i. SOCKET TORCH CONTROL PUSHBUTTON
Socket ( Rif. 12 - Fig. 1 page 3) for connection of the torch pushbutton.
j. GAS OUTLET FITTING (GAS OUT)
Connect the gas pipe leading ( Rif. 13 - Fig. 1 page 3) to the elec-
trode torch to this fitting and fully tighten.
k. REMOTE CONTROL SOCKET
( Ref. 16 - Fig. 1 page 3)
Remote control device. This is supplied on request and, when
connected, allows for remote variation of the amount of current
necessary so that the operator does not have to interrupt welding
or abandon the work area.
CAUTION: This optional automatically disables the amperage selector.
3.2

REAR PANEL

GAS CONNECTION
Insert the cylinder gas pipe into this fitting and secure with a hose clamp.
BEFORE INSERTING THE MAINS PLUG, IN ORDER TO AVOID THE
BREAKING OF POWER SOURCE, CHECK IF THE MAINS CORRESPOND
TO THE WISHED MAINS SUPPLY.
✍

MAINTENANCE

4.0 MAINTENANCE
Disconnect power before maintenance.
Service more often during severe conditions.
Every three (3) months, perform the operations below:
a. Replace unreadable labels.
b. Clean and tighten weld teminals.
c. Replace damaged gas hose.
d. Repair or replace cracked cables and cords.
Every six (6) months, perform the operation below:
a. Blow out the inside of the unit.
b. Increase frequency of cleaning when operating in dirty or dusty conditions.

5.0 OPTIONALS

Consult the area agents or the dealer.
(GB) 4
GB