Radio - Jacuzzi Flexa Double Bedienung-Wartung

Radio

The radio can be turned on during any function, and also when
the functions are off (but with the display on). Reception is ei-
ther AM or FM. It is equipped with automatic search and al-
lows you to store up to 6 stations in the two bands.
I Turning on power
• (fig. 1) Press the "ON/OFF" key. The display will show the
frequency of the last broadcaster you tuned to and the band
(AM or FM).
I Adjusting Volume
• (fig. 2) Press the "VOL" key. The display will show a numer-
al between 1 and 31.
• (fig. 3) Press the "+" or "-" key to turn the volume up or down.
Every time you press the "+" or "-" key, the value shown in-
creases or decreases, up to a maximum value (31) or mini-
mum (1). If you hold down the key, the volume variation is con-
tinuous, unless you reach the maximum or minimum values.
• Once you have selected the required volume, the value con-
tinues to be displayed for about 4 seconds. After that the time
appears again.
I Station selection
• (fig. 4) Press the "MEM" key. The display shows the chan-
nel and then the broadcast frequency currently in use.
• (fig. 4) To change the band type (AM or FM), press the cor-
responding button.
• To change the station, hold down the key "+" or "-" until you
reach the desired frequency. Frequency change starts out slow-
ly, and picks up speed. To fine tune the frequency, use the "+"
or "-" keys by pressing them and quickly releasing them.
NB: models with CD-tuner have and automatic station search
system. When you press the "+" or "-" keys, frequency scan-
ning begins and the radio tunes to the first station which
provides a clear signal. At the end of the scale, the search
starts again from the beginning.
• Once you have selected the required station, the frequency
value remains displayed for about 8 seconds, after this, the
time appears again.
NB: the selected station will be lost when the radio is turned
off if it is not memorized (see below).
I Memorizing the stations
The memorized stations are shown on the display by the word-
ing "CH#", where # indicates the number of the channel.
• (fig. 5) To change from one station to another, press the
"MEM" key. The display will show the channel number ("CH#")
followed by the frequency assigned to that channel.
• Adjust the frequency and/or the type of band, following the
instructions given in the "Station Selection" paragraph.
• Once you have selected the station to be memorized, hold
down the "MEM" key. If the value on the display is flashing, it
means that memorization has occurred.
I Shutdown
• (fig. 6) Press the "ON/OFF" key again. The radio switches
off, and the time is once again shown.
NOTE
If at power up you see the message "rAno" it means there is a
problem. Contact an authorized Jacuzzi Service Centre.
When you turn the radio back on, the volume automatically is
at the factory-set level.
1
3
5
52
2
4
6