JRG Sanipex MT
5.3
Replacement of pipe cutter wheel
Open the pipe cutter by operating the
lever. Push lock bolt (e.g. nail of Ø
3 mm) through the drilled hole. Thus
the pipe cutter remains secured open.
Danger: Resile of pipe cutter wheel
Fingers can be hurt!
The pipe cutter wheel have to be changed only with locked lever
Remark: Cutting wheel - axis
Since January 2002 only hubbed axis are used. These axis replaces the
cylindrical bolt with socket. A hubbed axis have to be used, as far as
not yet available, changing the cutter wheel. The hubbed axis has the
art.-no. 16 003 15.
cylindrical bolt + separate socket
82
®
Detach the screw with a screwdriver.
Replace the pipe cutter wheel. Tighten
the screw and remove the lock bolt
Istruzioni di montaggio
Replace to
hubbed axis