JRG Sanipex MT
5.1.4 Mounting guides for flaring process JRG Sanipex MT
Remark
Ending the flaring process
The tension unit must only be opened after the ready-lamp on the
hydraulic aggregate lights up.
Warning
Correcting flange
The pipe should not be touched or deflashed otherwise the resulting
flange is too long.
Exception:
If the pipe cannot be cut back with a plastic pipe cutter then the pipe
must be deflashed and freed from shavings after the expansion
process.
Remark
Controlling the connection by eye:
Securing ring is visible =
Connection not tightened
®
Installation instructions
d50 + d63
®
Securing ring is not visible =
Connection tight
79