Operating - And Display Elements; Light-Emitting-Diode Display (Led) - JRG Sanipex MT 4810.000 Bedienungs- Und Wartungsanleitung

JRG Sanipex MT
2

Operating - and display elements

2.1 Start button on the hydraulic device
The start button on the hydraulic device is used for triggering the expansion process.
(Refer to chapter 5.1.1).
This start button must not be utilised for bending pipes!
2.2 Start Button on the bending device
The start button on the bending device is utilised for triggering the bending process.
(Refer to chapter 5.2.2).
2.3

Light-emitting-diode display (LED)

No. Designation
13 Mains voltage
14 Expansion
mode
15 Bending mode
16 Servicing
17 Frost
18 Over-tempera-
ture
®
Lights-up ...
when the device is switched on
and mains voltage is present
when the device is ready for
expanding pipe ends
when the device is ready for
bending pipes
after 70'000 working cycles.
The complete JRG Sanipex
device in the interest of opera-
tional safety has to be returned
to the sales point at the next
opportunity for an overhaul.
at an oil temperature of
between -5°C up to -15°C the
device can be operated normally.
Recommendation: Connect an
expanding- or a bending unit to
the hydraulic unit. Start the ex-
panding respectively the ben-
ding process (without fixed pipe
inside). Repeat this procedure,
until the LED will extinguish.
at an oil temperature of
between +50°C up to +70°C
the device can be operated
normally.
Installation instructions
Blinks ...
after an abortion of the expan-
sion process (refer to chapter 6)
after an abortion of the bending
process through a too long operat-
ing time (refer to chapter 6)
after 75'000 work cycles, the
complete JRG Sanipex MT toll in
the interest of operational safe-
ty must not be utilised anymore
and immediately has to be
returned to the sales point for
an overhaul (refer to chapter 6)
at an oil temperature of below
15 °C (refer to chapter 6)
at an oil temperature of above
70 °C (refer to chapter 6)
69