Replacing The Lamp; Closing The Door - AEG S53600CSW0 Benutzerhandbuch

42 www.aeg.com

REPLACING THE LAMP

1

CLOSING THE DOOR

1. Clean the door gaskets.
If necessary, adjust the door. Refer to
2.
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
2
The appliance is equipped with a longlife
LED interior light.
1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. If needed replace the lamp with a light
of similar characteristic and power. It is
suggested to use Osram PARATHOM
SPECIAL T26 0.8 Watts.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the
lamp comes on.