Software Set-Up - Velleman CAMIP5 Bedienungsanleitung

• Follow the instructions on the screen. Click Next to start the software installation.
• Click Next again.
• To finish software installation, the computer must be restarted. Select 'Yes I want to restart my
computer now' and click on Close.
• After reboot, the IP Camera Tool icon appears on the desktop.

8. Software set-up

• Make sure all connections are properly made (see also §6) and double click on the IP Camera
Tool icon to start the software.
8.1 IP Camera Tool
• The software starts searching for cameras over the LAN. 3 Situations can occur:
o No cameras are found on the LAN. If after 1 minute the software does not detect any cameras,
check all cabling of the system and make sure the camera is powered.
o Cameras are found and listed (see image below).
o Cameras are found but are not on the same subnet as the PC. The message 'Subnet doesn't
match, dbclick to change' appears. Change the subnet settings via the network configuration
menu (see further).
03.05.2010
CAMIP5
5
Rev.01
©Velleman nv