Velleman CAMIP5 Bedienungsanleitung Seite 9

• Press on the
required.
• Press on the
Notes:
• When an icon is pressed, it changes to the stop icon
function.
• The recorded file name is cameraname_timestamp.avi
e.g.
• The path where the movies will be stored can be set by the administrator in the For
Administrator screen (see further).
For Operator layout
• When entering an administrator password, the user can open the For Operator layout.
• In this layout, it is possible to pan/tilt the camera using the control panel:
auto tilt (vertical movement)
auto pan (horizontal movement)
make alarm output [11.1] active.
Note: when the camera is in auto tilt/auto pan mode, motion detection and external alarm input are
disabled!
• Check the Flip checkbox in case the image is shown upside down.
• Check the Mirror checkbox to mirror the image.
• Set the resolution to 320*240 or 640*480.
• Set the mode to 50Hz or 60Hz.
Note: the camera is not suitable for outdoor use! The outdoor setting could be used in case the
camera is pointed towards a bright natural light source.
• Set the brightness and contrast of the image with the "+" and "-" buttons.
03.05.2010
icon to enable the cameras' speaker/audio port; a PC microphone (not incl.) is
icon to start recording the selected cameras' images.
Counter_20081211134442.avi
Press on the arrows around the blue button to move in that
direction.
Press and hold to move faster.
Press in the centre to start auto-scanning the whole area.
CAMIP5
. Press this icon to stop the underlying
stop auto tilt
stop auto pan
deactivate alarm output
9
Rev.01
©Velleman nv