Software-Installation - Velleman CAMIP4 Bedienungsanleitung

the bottom hole (camera resting on top of the bracket), mount the sunshield [4] by using the top
hole and the included bolt and washer.
• Point the camera towards the zone of interest and tighten the position bolt [6].
• Connect the power connector [C] to the 12VDC power supply (incl.).
• Connect the BNC connector [B] to a monitor (not incl.) and/or to a computer network via the RJ45
connector [A]. If in doubt, contact your local network service provider.
6. Software installation
• The camera comes with a CD-ROM containing the CamView software. Insert the CDROM into a
suitable computer (refer to §9 - Technical specifications).
• Locate the CamViewInstaller-V1.04.xx.exe (xx is de current version number) and double click on
it. The installation starts and the welcome screen is shown.
• Click Next >. The Select Packages screen is shown.
• If Framework 2.0 is already installed on the computer, uncheck the checkbox. If in doubt, leave it
checked, the computer will check.
• Click Next >. The Installation Folder screen is shown.
• Select the desired location with the Change... button and click Next >. The Shortcut Folder
window appears.
• Select the desired location from the dropdown menu, select whether to make shortcuts available
for all users or not and click Next >. The Ready to Install window appears.
17/07/2009
CAMIP4
4
Rev. 02
© 2008 Velleman nv