Software-Installation - Velleman CAMIP5 Bedienungsanleitung

11.1
11.2
6. Hardware installation and operation
• Choose a location for the camera, keeping following guidelines in mind:
• Do not install the camera in locations where extremely high or low temperatures or excessive
vibrations may occur.
• Avoid mounting the camera near high electro-magnetic fields.
• Do not aim the camera at the sun or other extremely bright objects.
• The camera can be used free standing or in combination with the included mounting bracket. When
the mounting bracket is used, attach it to the wall or ceiling using the 2 included screws. Place the
CAMIP5 on top and secure it with the centre screw. Determine the desired angle and tighten the
joint screws.
• Connect the antenna to the antenna connector [7] and/or connect a network cable (included) to the
RJ45 jack [9].
Note: it is possible to connect the camera straight to the RJ45 port of a computer. In this case a
crossed cable (not incl.) should be used and network settings must be configured manually.
• Use of the alarm connector:
• Connect an external alarm switch (e.g. a PIR sensor) to the alarm input [11.3] and the input
GND [11.4]. The CAMIP5 can be programmed to handle events triggered on this input,
• Connect an alarm output device (e.g. a buzzer) to the 5V DC output [11.1] and the output
(GND) [11.2]. In case an alarm condition exists, the output [11.1] will be high (5V DC).
Note: the output can also be enabled with the
further).
• When desired, an external speaker system can be connected to the audio output [8].
• Plug the DC connector of the power adaptor into the 5VDC input jack [12]. Only use the included
adaptor or one with the same specifications.
• Plug the adaptor into a suitable mains outlet (100~240V AC/50~60Hz).
Notes:
• It takes about 30s for the camera to initialise.
• During initialisation the camera will start moving to test the pan/tilt functionality.
• When the image appears out of focus, turn the lens [3] to adjust.
7. Software installation
• Insert the included CD-ROM into a suitable computer system (not incl.).
System requirements: CPU ≥ 2.06 GHz / memory ≥ 256MB / network ≥ 10 MB / video card ≥
64MB memory / recommended OS: Windows 2000 or XP.
• Locate the software installer IPCamSetup.exe and double click it.
03.05.2010
CAMIP5
+5V DC output
output (GND)
11.3 alarm input
11.4 input (GND)
and buttons in the 'for operator' window (see
4
Rev.01
©Velleman nv