Safety.warnings.for.the.electrical.equipment; Residual.risks - VM Motori R750EU5 Gebrauchsanweisungenhandbuch

–All packaging components should be di-
sposed of in accordance with the legisla-
tion in force in the country where disposal
takes place.
–When installing the engine, ensure a
suitable air renewal in the environment to
protect the operators from a high concen-
tration of harmful substances.
–During operation and maintenance, do
not throw away polluting products (oils,
greases, etc) in the environment and
carry out the differentiated waste disposal
SAFETY WARNINGS FoR THE ELECTRICAL EQUIPmENT
The electrical equipment was designed
and manufactured according to the provi-
sions of the standards in force on the mat-
ter. The list specifies some warnings to be
complied with for the correct operation of
the electrical equipment.
–Do not use boosters or quick starters to
start the engine.
–Do not disconnect the electrical power
supply when the engine is ON.
Before disconnecting the electrical
power supply, turn off the engine and
wait for at least 30 sec. so that the
electronic control unit can perform the
"after -run" procedure.
RESIDUAL RISKS
During the design and construction
phases, the Manufacturer paid special
attention to the aspects which are liable to
cause any risk for the safety and health of
people interacting with the engine.
Despite this, some potential and hidden
risks still exist.
English
R750EU5 - IE3 - TE4 - IE4 - ISE4
according to the composition of the diffe-
rent materials and in compliance with the
legislation in force. Electric and electronic
components should be carried out as
special waste.
–Keep the exhaust pipelines efficient to
limit the noise level of the engine and to
reduce atmospheric pollution.
–While decommissioning the engine,
divide all the components depending on
their chemical composition and dispose of
them accordingly.
–Before performing arc welding on the
frame where the engine is installed,
ALWAYS disassemble the electronic
control unit and protect all electrically
connected devices that are installed
close to the negative pole (mass).
Danger of injuring your arms
Do not put your hands inside any movin-
gpart.
Danger of being burnt
Pay attention to hot surfaces
23 Ed.8 / 0-202
GB