Maintenance.in.case.of.engine.inactivity - VM Motori R750EU5 Gebrauchsanweisungenhandbuch

mAINTENANCE IN CASE oF ENGINE INACTIVITY
After a period of inactivity, it is necessary
to carry out a few maintenance interven-
tions before starting the engine again to
GB
ensure its maximum efficiency conditions.
– Check the charge of the battery and the
liquid level.
–Make sure the electric contacts are intact
and properly working.
– Carry out the operation diagnosis of the
engine.
–Check the oil level, and, if necessary, top
up or replace it according to the esta-
blished intervals (See "Routine mainte-
nance (after running-in)")
–Replace the oil filter according to the
established intervals (See "Routine main-
tenance (after running-in)")
–Check the coolant level, and if neces-
sary, top up or replace it according to
the established intervals (See "Routine
maintenance (after running-in)")
–Replace the fuel filter according to the
established intervals (See "Routine main-
tenance (after running-in)")
English
R750EU5 - IE3 - TE4 - IE4 - ISE4
– Replace the air filter according to the
established intervals (See "Routine main-
tenance (after running-in)")
– Tension again the transmission belt
– Check the tightening of the hydraulic
unions (See "Control screw tightening and
union sealing")
–Check the rubber gaskets and relevant
fixing clips to ensure they are undama-
ged.
– Use a cloth soaked in a degreasing
product to remove the external protective
treatment.
–Start the engine and run it at minimum
speed for a few minutes (See "Engine
ignition and turning off")
– If no anomalies are detected, bring
the engine to its operating temperature
(70÷80°C).
–Turn off the engine and check again the
engine oil and coolant level.
46 Ed.8 / 0-202