Specifications - Makita AR411HR Betriebsanleitung

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Air pressure
Screw length
Screw capacity
Safety device
Drive adjustment
Screw feed mechanism
Minimum hose diameter
Pneumatic tool oil
Dimensions (L x W x H) (with hook)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Wear safety glasses.
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for fixing plaster boards.
Noise
The typical A-weighted noise level determined accord-
ing to EN792:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
WARNING:
Wear ear protection.
Vibration
The vibration total value determined according to
EN792:
Vibration emission (a ) : 2.5 m/s
h
Uncertainty (K) : 1.5 m/s
) : 78 dB(A)
pA
2
or less
2
1.76 - 2.26 MPa (17.6 - 22.6 bar)
Coil tape collated screws 100 pcs
Contact arm system
Dial type (adjustment range: 6 mm)
Feed piston system
ISO VG32 or equivalent
276 mm x 120 mm x 316 mm
NOTE: The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration emission value may
also be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
Makita declares that the following Machine(s):
Designation of Machine: Pneumatic Auto Feed Coil
Screwdriver
Model No./ Type: AR411HR
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents: EN792, EN ISO
11148
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
26.5.2015
Yasushi Fukaya
Director
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
5 ENGLISH
AR411HR
25 - 41 mm
5.0 mm
2.0 kg