Maintenance; Optional Accessories - Makita AR411HR Betriebsanleitung

trigger and pull it again while pressing the contact arm
against the workpiece.
Continuous drive action
While the trigger is pulled, you can drive the screws by
pressing the contact arm to the workpiece.
Cutting linked sheet
CAUTION:
Always disconnect the air hose
from the tool before removing the linked sheet.
When using linked sheet screws, the linked sheet
will be ejected from the driver guide as you drive the
screws. Tear away the ejected sheet by twisting as
shown in the figure.
► Fig.19: 1. Ejected linked sheet

MAINTENANCE

CAUTION:
Always disconnect the air hose
from the tool before attempting to perform inspec-
tion or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Removing jammed screw
1. Disconnect the air hose from the tool.
2. Open the door and magazine cap then tear off the
linked screw sheet.
3. Insert metal bar into the screw ejection hole and
hit it with a hammer lightly.
► Fig.20: 1. Metal bar 2. Hammer
4. Remove the jammed screw with a flat-blade
screwdriver or other similar tool.
► Fig.21
Draining water from the tool
Remove the air hose from the tool and place the tool so
that the air fitting faces down to the floor. Leave it for a
while until the water inside the tool is drained.
► Fig.22: 1. Air fitting
Storage
When not in use, always disconnect the air hose from
the tool and attach the cap to the air fitting. Clean the
iron dust that adhered to the magnet using an air duster.
The tool should be stored in a warm and dry place.
► Fig.23: 1. Cap
Maintenance of compressor and air
hose
Observe the following instructions to keep the optimum
performance and avoid possible tool failure.
• Always drain the compressor tank after each
operation;
• Keep the air hose away from heat (over 60°C,
over 140°F) ;
• Keep the air hose away from chemicals such as
thinner, strong acids or alkalis;
• Route the air hose away from obstacles which
may become dangerously caught on during
operation;
• Route the air hose away from sharp edges and
areas which may lead to damage or abrasion to
the hose.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Air hose
• Safety goggles
• Driver bit
• Coil tape collated screws
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
10 ENGLISH