Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita 6822 Bedienungsanleitung

ENGLISH
1-1. Locking sleeve
2-1. Approximately 1 mm
2-2. Locator
3-1. Approximately 1 mm
3-2. Locator
4-1. Speed control screw

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 81 dB (A).
Uncertainty is 3 dB(A).
The noise level under working may exceed 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
EC-DECLARATION OF CONFORMITY
Model; 6822
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
000230
Explanation of general view
4-2. Switch trigger
4-3. Lock button
4-4. Low
4-5. High
5-1. Reversing switch lever
6-1. Locator
Model
Self drilling screw
Drywall screw
Bit shank size
-1
)
Overall length
Net weight
Safety class
2
.
CE2007
ENE033-1
Responsible Manufacturer:
Makita Corporation
ENF002-1
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND

SPECIFIC SAFETY RULES

ENG003-2
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to screwdriver safety rules. If you use this power
tool unsafely or incorrectly, you can suffer serious
personal injury.
1. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
ENH101-8
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
3
6-2. Locking sleeve
7-1. Locator
7-2. Bit
7-3. Magnetic bit holder
6822
6 mm
5 mm
1/4" Hex
0 - 4,000
258 mm
1.3 kg
/II
Tomoyasu Kato
Director
GEB017-1