Faults Are Monitored As Follows; Engineers Facilities - detectomat DCC 8 plus Bedienungsanleitung

5 Engineers Facilities:

4.3

Faults are monitored as follows

Indication on the front panel
GENERAL FAULT
+ blinking in yellow
(1 blink per second) LED of the zone,
where the fault is occurred.*
GENERAL FAULT
On + blinking
SOUNDER FAULT/ DISABLE
GENERAL FAULT
On +
POWER SUPPLY 230V
Off
GENERAL FAULT
On +
POWER SUPPLY 230V
On
GENERAL FAULT
GENERAL FAULT
GENERAL FAULT
GENERAL FAULT
GENERAL FAULT
GENERAL FAULT
* It is possible for a fault to arise simultaneously in several zones - the LEDs of the zones with fault will blink.
** Where the fault has occurred in the sounder circuit of the expander, the SND1, SND2, SND3 or SND4 LEDs
If the specific module, depending of the number of the circuit.
*** Only in Master or Slave modes.
DCC 8 plus has the ability to select various facilities to assist the engineer during installation and
testing of the system. These facilities include:
Zone Test:
Isolate Sounders:
Disable/Enable Zone:
Version 1.0
Indication on the control module
-
SND1 SND2 SND3 SND4
LED , , or
depending on the number of the
circuit.**
АС LED lights permanently.
АС LED blinking.
LOW/LOST
ВАТТ LED lights
permanently.
LOW/LOST
LED blinking.
ВАТТ
RP
Т LED***
AUX
LED
EARTH
LED
uPFAULT
LED
Note!
The fault indication does not show immediately. There is a delay in
reporting depending on the type of the fault. After all faults are corrected the
panel must be set to NORMAL MODE manually by pressing [ Reset ].
Individual zones can be tested and activated without the need
to return to the panel to effect a RESET. This is done
automatically by the panel.
System can be tested without operating the Sounder circuits.
Each zone can be disabled / enabled.
7
Bedienungsanleitung DCC 8 plus
Fault description
- Zone fault
- open or short circuit.
- Detector head removed.
- Sounder circuit fault
,
- Open or short circuit.
Mains supply loss.
Battery charging fault.
Battery loss.
Low battery charge level.
- no connection to Repeater panel.
- Repeater fault.
Auxiliary supply fault.
Short circuit to earth.
Processor fault.