Led Indicators; Establishing A Bluetooth Connection - Silvercrest SBLS 6 A1 Bedienungsanleitung

BB58 B%OXHWRRWKB6SHDNHUB[:B%ERRN 6HLWH  'RQQHUVWDJ  -XOL    

LED indicators

NOTE: the function indicators can also be combined.
Example: the LED indicator is lit red and flashes in blue, if a Bluetooth
connection is established while charging.
LED indicator|3
LED flashes
blue/red
LED flashes blue
LED flashes green
LED flashes red
LED is lit red

7.1 Establishing a Bluetooth connection

NOTES:
• The identification of the device is "SBLS|6|A1".
• After turning it on, the device automatically tries to reconnect to
the last paired device or to establish a new connection.
• Please observe that the establishment process of the connection
may vary slightly depending on the device and the software
used.
• The device switches itself off, ...
... if no Bluetooth connection is established within 10 minutes or
... if it does not receive a signal for 10 minutes.
• If the device has switched off automatically, first switch it off by
means of the ON/OFF|9 switch before being able to switch it
back on again.
• Depending on e.g. the volume, the device may be used for a peri-
od of approx. 10 hours while the Bluetooth connection is estab-
lished.
1. If necessary, remove the plug of the 3.5 mm stereo jack cable|10
from the socket AUX|8.
2. Switch on the device using the ON/OFF|9 switch. The LED|3 is
lit green. An acoustic signal sounds. Then the LED|3 flashes
blue/red.
Function
• Device attempts to make a connection to
the most recently paired device
• Device sends device identification
Bluetooth connection is established
Connector of the 3.5 mm stereo jack
cable|10 is plugged into the AUX|8 jack
socket
The battery must be charged
The battery is being charged
49
GB