Inhaltsverzeichnis
Werbung
Area
Control-panel display
Print
Copy
Troubleshooting
Symptom
Blank
Button on the touch screen appears gray
with "!" markers
Device does not recognize Letter/A4
paper loaded in the tray
Does not respond or there is an incorrect
response to touch.
Not printing
Jams
Blank pages
Buttons on the touch screen appear gray
1)
Make sure that the power cable is connected to a working
power outlet.
2)
Make sure that the device is turned on. See page 10 for
more information.
3)
If the status lights on the left side of the control panel
are functioning, check the display contrast by using the
brightness-adjustment wheel.
1)
Make sure that the scanner lock is unlocked. See page 6 for
more information.
2)
Turn off the device, and then turn it on again.
Make sure that the paper is loaded correctly. See page 8 for
more information.
1)
Turn off the device.
2)
Hold down the # and C keys while turning on the device.
3)
Release the keys when a small square appears at the upper
left corner.
4)
Touch the small square using a pen.
small square in the upper left corner only ONCE; the dot
will not disappear when touched. As soon as the
square is touched, another square appears at the lower
right corner. Both squares appear at the same time.
5)
Touch the small square at the lower right corner using a pen.
6)
Calibration is complete and the device will continue booting
up.
1)
Check the network or USB cable. See page 9 or 15 for
more information. If using a network cable, the green and
yellow lights at port should be lit.
2)
If you are printing over a network, print a configuration
page and make sure that the IP address is correct.
3)
Reinstall the print driver.
1)
Make sure that the orange packing tape and cardboard
have been removed. See pages 4 and 6 for more
information.
2)
Make sure that you are using supported paper. See the user
guide on the CD for more information.
3)
Make sure that the paper is loaded correctly. See page 8
for more information.
Make sure that the strip is removed from the print cartridge.
See page 7 for more information.
1)
Make sure that the scanner lock is unlocked. See page 6 for
more information.
2)
Turn off the device, and then turn it on again.
35
Cause/Remedy
Caution: Touch the
Werbung
Inhaltsverzeichnis
Fehlerbehebung
