Troubleshooting - Ryobi RLM53190YV Bedienungsanleitung/Übersetzung Der Originalanleitung

TROUBLESHOOTING

Problem
Handle positioned incorrectly.
Handle not in
correct position.
Quick-release knobs not tightened.
No spark.
No petrol.
Mower does not
start.
Engine is fl ooded.
Starter rope pulls harder now than
when new.
High grass, rear of mower housing
and blade are dragging in heavy
Mower is hard to
grass, or cutting height too low.
push.
Wheel assembly needs cleaning.
Blade is unbalanced.
Mower is vibrating
at higher speed.
Bent motor shaft.
Mower is not Wet grass clippings are sticking to the
mulching properly. underside of the deck.
Mower is not
Cutting height set too low.
bagging properly.
Possible cause Solution
Check to be sure that the pin of the lower handle
snapped into proper position.
Tighten handle quick-release knobs.
Use spark tester to check for proper spark plug
operation.
Check the fuel valve set to open.
Fill mower with petrol. If mower still does not start,
contact a servicing dealer.
Wait 15 minutes, then try starting mower again. Do not
prime before attempting to start.
Contact a servicing dealer.
Raise the cutting height.
Clean wheel assembly.
Replace the blade.
Stop the engine, disconnect the spark plug wire from the
spark plug, and inspect for damage. Have it repaired by
an authorised service center before restarting.
Wait until the grass dries before mowing. Clean the
underside of the mower deck.
Raise the cutting height.
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
13