Descale Mode - Atag CS4492T Anleitung

DESCALE MODE

When you see the messages ("Machine needs to be decalcifi ed" and see the below picture 1)
on the display, the machine needs to be descaled.
1 Pour 500 ml mixed solution of descaler
and clean water in the water tank.
Regarding to mixing ratio, refer to the
user manual of descaler.
3
Press Menu and turn the Multi-
function Selector to choose 'Cleaning'.
5 Press Next/Start. The machine displays
50 minutes and starts descaling.
Cleaning Mode: 40 min
Rinse Mode: 10 min
When it has progressed for about
40 minutes, the machine displays
"10:00" and stops operating with a
beep.
Remove the tank and empty any
remaining mixed water.
2 Close the lid of water tank before
installing into main unit.
4
Press Next/Start to confi rm. Turn the
Multi-function Selector to choose
'Decalcify'.
6 Wash the tank with water and fi ll up to
the maximum line with clean water.
Put it back into the main unit.
Press Next/Start. A rinsing process
takes place with clean water. After
10 minutes later, the descale mode will
be completed.
When '10:00' is displayed, you have
to operate the rinse mode within
25 minutes. If you do not, the set will
be reset after 25 minutes and then you
will perform the descale mode again.
EN 43