Attaching The Connector Cap - Sony DSBK-140 Installationsanleitung

Installation
5

Attaching the Connector Cap

When the DV IN/OUT connector is not being used, put the
supplied connector cap on the connector.
18
Note
When lowering the levers, one or both of them may not
properly seat inside the DSR-70/70P case.
If a lever is positioned as shown in the right side of the
figure below, the DSR-70/70P battery panel will not close.
Before attempting to replace the battery panel, check to
make sure that the levers are properly seated under the
board retaining rail, fully inside the DSR-70/70P case.
Replace the DSR-70/70P battery panel and secure it using
the screws.
Note
Before replacing the battery panel, make sure again that
the harness is not over any board levers. Be sure to pass
the harness over the boards and push its slack into the
space between boards.
Connector cap