Installation and System Setup
Installation & System Setup
Setting Up the Projector
1.
Stick the mounting position paper on the wall at
proper height according to the horizontal line.
2.
Screw 5 screws on the hole of the mounting
position paper.
.
Hang the steel mounting plate by aligning the
5 screws with the slotted holes. Put on the 5
screws. Use appropriate screw type
4.
Attach safety strap to secure location on wall.
5.
Hang the projector by aligning and hooking the
unit on the steel mounting plate.
6.
Start up the projector.
7.
Set up the white board. There are 2 horizontal
line, 85" and 50" Line, to decide the screen size.
If the white board follows the 85" Line, then
the screen size will be 85". If the white board
follows the 50" Line, the screen size will be
50".
8.
According to the screen size decided to adjust
arm length, use the longest arm length for 85"
screen size and shortest arm length for 50"
screen. Connect cable dock and power.
12
M
Digital Media System 800 Series
™
© M 2006. All Rights Reserved.