3M Digital Media System 800 Serie Betriebsanleitung Seite 7

M ™ Digital Media System 800 Series
• To reduce the risk associated with hazardous voltage:
- Do not remove any screws other than those specified in the lamp replacement instructions.
- Always plug projector into a grounded outlet.
- Do not use in wet environments.
- Do not use in an outdoor environment.
- Replace the power cord if damaged.
- Do not attempt to service the projector other than performing routine lamp replacement. Service
should only be performed by a M authorized service provider. Aside from the projection lamp
module, there are no user serviceable parts inside the unit.
- Do not modify this projector or power cord.
- Disconnect power cord when the projector is not in use, during lamp replacement, and while cleaning.
- Do not allow water or other liquids to enter the projector.
• To reduce the risk associated with hazardous voltage and/or fire:
- Use a properly rated extension cord. Consult an electrical professional if you have questions.
• To reduce the risk associated with hot surface of lamp cartridge:
- Wait at least 60 minutes for the lamp assembly to cool before replacing.
• To reduce the risk associated with choking:
- Keep batteries away from children and pets.
• To reduce the risk associated with environmental contamination due to mercury:
- Hg: Lamp in this product contains mercury. Dispose of lamp according to local, state, or federal laws.
See www.lamprecycle.org or call 1-800-28-171.
• To reduce the risk associated with lamp rupture related hazards:
- In event of lamp rupture, call M authorized service provider for repair. Ruptured lamp repair is
not user serviceable.
- Wash your hands thoroughly if contact with ruptured lamp debris has taken place.
- Ventilate the area where the lamp rupture occurs. The lamp operates at high temperature.
• T o reduce the risk associated with hazard voltage, and/or impact, and/or tripping, and/or
intense visible light:
- Do not use this projector around unsupervised children.
• To reduce the risk associated with muscular strain:
- Always use more than one person when installing or removing the projector.
• To reduce the risk associated with impact, and/or pinch:
- Use only M supplied wall mounting hardware.
- Follow all installation instructions carefully.
- Make sure mounting hardware is securely anchored to a solid structure.
- Make sure set screws are properly secured to wall mounting plate.
• To reduce the risk associated with impact:
- Use only on smooth or level flat surfaces.
- Do not use on a structure that is prone to vibration, movement, or chance of impact.
- Do not hang on, or place weight on the projection arm.
• To reduce the risk associated with various hazards related to the projector:
- Please read, understand and follow all safety information contained in the operator and product
safety guide prior to installation and use.
• To reduce the risk associated with sharps, premature lamp failure, exposure to mercury:
- Always handle the fragile lamp module with care.
- Replace the lamp module when the lamp replacement message appears.
- Never replace the lamp module with a previously used lamp module.
• To reduce the risk associated with radio interference
- This is a Class A product. In a domestic environment, this product may cause radio interference in
which case the user may be required to take adequate measures.
© M 2006. All Rights Reserved.
m WARNING
Introduction
7