Safety Measures - Vitek VT-1480 GY Betriebsanweisung

HAND BLENDER SET
Description
Rotation speed control
1.
ON button "I"
2.
Turbo mode button «II».
3.
Motor unit
4.
Blender attachment
5.
Whisk gear
6.
Whisk for beating/mixing liquid products
7.
Mash making attachment gear
8.
Mash making attachment
9.
Chopper geared lid
10.
Chopping knife
11.
Chopper bowl
12.
Cleaning pusher for cubic mesh
13.
Pusher
14.
Processing bowl geared lid
15.
Cubic attachment driving shaft
16.
Cubic attachment knife
17.
Cubic attachment with removable mesh
18.
Clamps
19.
Cubic mesh
20.
Processing bowl lid clamp
21.
Processing bowl
22.
Shredding/slicing disc
23.
French fries disc
24.
Potato mud shredding disc
25.
Processor chopping knife
26.
Processor driving shaft
27.
Measuring cup lid
28.
Measuring cup
29.
Storage base
30.

SAFETY MEASURES

Before using the unit, read this instruction
carefully. Keep this instruction for future
reference.
Use the unit for intended purposes only, as
specified in this manual. Mishandling the unit
can lead to its breakage and cause harm to the
user or damage to his/her property.
• Before using the unit for the first time, make
sure that mains voltage corresponds to the
voltage specified on the unit body.
•
The blender set allows quick and effective
operation, but continuous operation time
should not exceed 1 minute while using
blender attachment, whisk, mash making
attachment and 20-30 seconds while chop-
VT-1480.indd 3
ping products in chopper/processor. Make
at least a two-minute interval between oper-
ation cycles.
•
Do not run the unit unloaded.
•
When using the blender attachment, cool
down hot products.
•
Do not use the unit outdoors.
• Use only the accessories supplied.
•
Before using the unit for the first time, wash
all the removable parts that will contact food
thoroughly.
•
Before using the unit, make sure that all the
parts are set properly.
• Place the bowls on a flat, stable surface.
•
Products should be put into the bowl before
switching the unit on.
• Do not overfill the bowls with products and
watch the level of liquids.
•
The chopping knife blades are very sharp
and dangerous. Handle them very carefully!
•
If rotation of the chopping knife gets hin-
dered, unplug the unit and remove products
that prevent blade rotation carefully.
•
Remove products and pour out liquids from
the chopper bowl only after complete stop
of the knife.
•
Do not touch the rotating parts of the unit. Do
not allow hair or clothes edges get into the
rotating zone of blender blades.
•
Never leave the operating unit unattended.
•
Always unplug the unit before cleaning or if
you do not use it.
•
Do not use the unit near hot surfaces (gas or
electric stove, oven).
• Provide that the power cord does not touch
sharp edges of furniture and hot surfaces.
•
Do not pull the power cord and do not twist it.
• Do not touch the plug with wet hands.
•
Do not use the unit if the power cord is dam-
aged.
• Do not try to repair the unit by yourself. If
there are any damages in the unit, apply to
the authorized service center.
•
In order to avoid risk of electric shock or fire,
do not immerse the unit, the power cord and
the power plug of the unit into water or other
liquids. If the unit was dropped into water:
do not touch water;
–
3
ENGLISH
02.08.2012 15:15:40