Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Stand-alone mode
Automatic mode
In automatic mode you can choose from 2 preset show programs.
1
Press the button MODE so many times until the display indicates the menu item Auto. Confirm with the
ENTER button.
2
Use the buttons UP and DOWN to select the desired show program (Au-1 or Au-2). Confirm again with
the ENTER button.
Sound-controlled mode
Thanks to the integrated microphone, the preset show programs can be played to the rhythm of the music
(sufficient bass beat provided).
1
Press the button MODE so many times until the display indicates the menu item Soun. Confirm with
ENTER.
2
Now press the button MODE so many times until the display indicates SEns. Confirm with ENTER. Use
the buttons UP and DOWN to adjust the microphone sensitivity to the sound volume of the music (S001
= low, S099 = high).
Preset colors
In the Stat mode the device will constantly emit one of 19 preset colors.
1
Press the MODE button so many times until Stat is indicated in the display. Confirm with the ENTER
button.
2
Use the buttons UP and DOWN to select one of nine colors (S 01 to S 19). Confirm again with the
ENTER button.
Individual color mix
In the color mode CoLo color intensity and strobe effects can be adjusted manually.
1
Press the button MODE so many times until CoLo is indicated in the display. Confirm with ENTER.
2
Now the display indicates r for the color red plus the corresponding brightness value. Use the buttons UP
and DOWN to adjust the brightness between r000 and r255. Confirm with the ENTER button.
3
Now the colors green (g000 to g255), blue (b000 to b255), white (U000 to U255), amber (A000 to A255)
and UV (u000 to u255) can be adjusted in the same way.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated in the display. Confirm with the ENTER button.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
26/36
00125914, Version 1.2
Werbung
Inhaltsverzeichnis
