Clutch Adjustment - Ingersoll-Rand QS1P28 Technische Produktdaten

EN

Clutch Adjustment

Disconnect the air supply from the Tool before proceeding.
The Clutch Adjusting Hole Cover has a left-hand thread. Rotate the Cover clockwise
to loosen or remove the Cover.
1. Unscrew the Clutch Adjusting Hole Cover far enough to expose the clutch adjusting hole in
the Clutch Housing.
2. Insert a 1/4" hex wrench into the Bit Holder and rotate the clutch mechanism until the area
having an opening between the faces of the Clutch Adjusting Nut Washer and Clutch
Adjusting Nut is visible.
3. Using a screwdriver that has a #1 Phillips tip, insert the tip of the screwdriver into the opening
and rotate the screwdriver to adjust the Clutch. Rotate the screwdriver clockwise to decrease
Clutch Spring tension and torque and counterclockwise to increase the tension and torque.
The most satisfactory adjustment is usually obtained by using the tool on the actual
application and increasing or decreasing the delivered torque until the desired
setting is reached. In any event, it is recommended that final adjustment be made by
gradual progression.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
WARNING
NOTICE
NOTICE
80165921_ed3