Back; Included - Sharp FU-S25E Bedienungsanleitung

Plasmacluster Indicator Lights
(Please refer page E-9)
Blue light
• When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode and the air in the
room is impure, the light will be activated and the unit will operate in Clean Mode.
• When the Plasmacluster ion operation is in ION SHOWER Mode, the light will repeat its colour cycles between
light and shade.
Green light
When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster Ion Mode and the air
in the room is clean, this light will be activated and the unit will operate in Ion Control Mode.
CLEAN - SIGN Light
The colour changes according to the air condition.
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the room air condition detected by the Odour Sensor when the
plug is inserted into the wall outlet.
• It is possible to have a green CLEAN-SIGN with impurities in the air at the time that the air purifier was just
introduced to the room environment. After a while, however, the base impurity rate will be adjusted to detect room
air condition correctly.
DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the conditions of the
air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash in green, orange and red.

BACK

Handle
Air Outlet
Data Label
Power Cord
Power Plug
(Sharp of plug depends on country.)
Clean Slightly Impure
Green Orange
E-5
Very Impure
Red

INCLUDED

• Operation manual