Basic Programming - Pentair Fleck 5800-SXT Handbuch

User Guide Fleck 5800-SXT
3.3. Description and components location
3.4. By-passing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture below.
Normal operation
4 . Programming
Note:
After 5 minutes without any button pressed, the unit returns to normal operation without saving.
4.1.

Basic programming

Note:
Day of Override
Note:
Regeneration time
A
Press and
B
Select the number of days of Override with
C
Press to validate the selection and advance to the next parameter.
Note:
D
Adjust the regeneration time with
E
Press to validate the selection and advance to the next parameter.
6 / 36
Downloaded from www.Manualslib.com
Brine
Drain
Mixing device
Outlet
Meter
Inlet
Softening System
In
The controller must be plugged to be programmed.
Menus are displayed in a defined and incremental order.
Determine the maximum number of days of operation without regeneration.
simultaneously for 5 seconds to enter the menus sequence.
Determine the time of regeneration.
and
manuals search engine
Down button
Up button
Display
Regeneration button
In Bypass
Out In
and .
.
Softening System
Out
Ref. MKT-UG-004 / B - 16.01.2018