Siemens SIPART PS2 Kompaktbetriebsanleitung Seite 35

2. Use the button to change from linear actuator to part-turn actuator until the display shows the following:
3. Call the "2.YAGL" parameter. To do this, briefly press the
automatically. The display shows the following:
4. Call the "4.INITA" parameter. To do this, briefly press the
5. Start the initialization process. To do this, press the
following:
The positioner runs through five initialization steps during the automatic initialization process. Displays for the
initialization steps from "RUN1" to "RUN5" are shown in the lower line on the display. The initialization process depends
on the actuator used, and takes up to 15 minutes.
6. The following display indicates that the automatic initialization is complete. The total angle of rotation of the actuator is
shown on the upper line on the display:
SIPART PS2 (6DR5...)
A5E03436620-05, 09/2014
button. This parameter has already been set to 90°
button. The display shows the following:
button for at least 5 seconds until the display shows the
33