Invacare HomeFill II IOH200AW Bedienungsanleitung Seite 17

4. Plug the opposite end of the power cord into the wall
socket.
Wall
Socket
Power
Cord
FIGURE 2.2 Installing the Power Cord
Connecting the Compressor to the Concentrator
NOTE: For this procedure, refer to FIGURE 2.3 on page 18.
1. Insert one end of the interconnect hose into the outlet
fitting on the back of the concentrator (Detail "A").
2. Insert the opposite end of the interconnect hose into the
inlet fitting on the side of the compressor (Detail "B").
NOTE: The metal tabs on the concentrator outlet fitting and the
compressor inlet fitting will pop out with an audible "click" when
the end of the interconnect hose is properly installed (Detail "C").
3. Loop any excess interconnect hose and secure to the back
of the concentrator with the fastening straps.
Part No 1145804
SECTION 2—INITIAL SETUP
Compressor
(REAR)
Electrical
Connection
17 HomeFill II Compressor
®