Manual Operation(Without Remote) - INVENTOR GR1VI32-12WF Benutzerhandbuch

Manual Operation
(Without Remote)
How to operate your unit without
the remote control
In the event that your remote control fails to
work, your unit can be operated manually with
the MANUAL CONTROL button located on
the indoor unit. Note that manual operation is
not a long-term solution, and that operating
the unit with your remote control is strongly
recommended.
BEFORE MANUAL OPERATION
Unit must be turned off before manual
operation.
To operate your unit manually:
1. Press the button on both side of the
indoor unit to loosen the panel, then
lift the front panel up, use the automatic
telescopic rod to prop up the panel.
2. Locate the MANUAL CONTROL button
on the right-hand side of the unit. Press
the recessed button with your nger or
the tip of a ballpoint pen.
3. Press the MANUAL CONTROL button one
time to activate FORCED AUTO mode.
4.
Press the MANUAL CONTROL again
to activate FORCED COOLING mode.
5. Press the MANUAL CONTROL
6. button a third time to turn the unit off.
Hold the panel by hand, and press the
middle position of the automatic
telescopic rod to close the front panel.
ƒPage 10
„
CAUTION
The manual button is intended for testing
purposes and emergency operation only. Please
do not use this function unless the remote is
lost and it is absolutely necessary. To restore
regular operation, use the remote control to
activate the unit.
A
3 3
A
Press here to loosen
the front panel
Automatic
telescopic rod
(press the middle
position to release)
Manual control button
ƒ Page 9 „