Specifications - Olympus LS-P1 Handbuch

• Noise may be heard when the voice
recorder is placed near an electric
lamp line, fluorescent light or a
mobile phone during recording or
playback.
<Data loss precautions>
• Recorded content in the internal
memory and microSD card may be
destroyed or lost due to reasons
such as operating errors, device
failure or repair.
• Also, when content is saved in the
memory for long period of time
or is used repeatedly, operations
such as writing to, reading from,
or erasing of contents may not be
possible.
• Making a backup of important
recorded information and saving
it on a PC's hard disk or other
recording media is recommended.
• Note that Olympus will assume
no liability for damages or lost
earnings resulting from recorded
data damage or loss, regardless of
the nature or cause thereof.
<Recorded file precautions>
• Note that Olympus will assume no
liability for recorded files being
erased or becoming unplayable
due to voice recorder or PC failure.
• Recording of copyrighted material
is permitted when the recording
is for your personal use only. Any
other type of use without the
permission of the copyright owner
is prohibited by copyright law.
<Voice recorder and microSD cards
disposal precautions>
• Even when formatting or erasing
are performed, only the file
management information of the
internal memory and/or microSD
card is updated and the recorded
data is not completely erased.
When disposing of the voice
recorder or a microSD card, be
sure to destroy it, format and
record silence until the recording
time runs out, or perform a similar
operation in order to prevent the
leakage of personal information.

Specifications

4 Recording formats
Linear PCM format
FLAC* format
MP3 format
* LS-P4 model only
4 Input level
- 60 dBv
4 Maximum working output
150 mW (8 Ω speaker)
4 Maximum output voltage
Recorder: â 150 mV
(according to EN 50332-2)
4 Recording media*
Internal NAND flash memory:
LS-P4: 8 GB
LS-P1: 4 GB
microSD card:
(Supports card capacities
ranging from 2 to 32 GB.)
* Some recording media
memory capacity is used as
a management area, so the
actual usable capacity will
always be slightly less than
the displayed capacity.
4 Bluetooth® Specification*
Standard:
Version 2.1+ EDR Support
Transmit Power Level: Class2
Communication Distance:
Line of sight approx. 10 m*
(max.)
Operational Frequency Range:
2.4 GHz to 2.4835 GHz
2 mW or less
Modulation Method: FHSS
Firmware: Ver. 1.0 or later
Compatible Profiles:
A2DP (Advanced Audio
Distribution Profile)
AVRCP (Audio/Video Remote
Control Profile)
HSP (Headset Profile)
HFP (Handsfree Profile)
SPP (Serial Port Profile)
*1 LS-P4 model only
*2 The communication distance
is guideline values. The
communication distance may
vary depending on ambient
conditions.
4 Speaker
Built-in 18 mm diameter round
dynamic speaker
4 Microphone jack
3.5 mm diameter; Impedance:
2 kΩ
4 Earphone jack
3.5 mm diameter; Impedance:
8 Ω minimum
4 Power source
Standard voltage: 1.5 V
Battery: One AAA dry cell
battery (model LR03), or one
Olympus nickel-metal hydride
rechargeable battery (always use
an Olympus BR404 for charging
with the recorder)
External power supply: USB-
connection AC adapter (model
A514; 5 VDC)
4 External dimensions
108.9 × 39.6 × 14.4 mm (Not
including largest projection)
4 Weight
75 g (including battery)
4 Operating temperature
0 to 42°C (32 to 107.6°F)
Note that voice recorder
specifications and appearance
1
are subject to change without
prior notice for performance
improvements or other upgrading.
2
For customers in North and
South America
FCC Notice
• This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation.
• This equipment generates, uses,
and can radiate radio frequency
energy and, if not installed
and used in accordance with
the instructions, may cause
harmful interference to radio
communications.
EN
9