Parkside PDSS 400 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 51

applications for which it was
designed!
Do not overburden the device.
„ „
Never use hydrogen,
„ „
oxygen, carbon dioxide
or other bottled gasses to
power this tool as doing so
may result in explosion, thus
severe injuries.
Regularly maintain and clean
„ „
the device as required (see
chapters „Maintenance" and
Cleaning and care").
Check the device for damage
„ „
prior to initial operation. Al-
ways verify the tool's proper
condition before every use.
Remain alert at all times! Un-
„ „
foreseen machine movement
due to reaction forces or the
tool or counter bearing break-
ing may result in injuries.
Risk of injury due to chips be-
„ „
ing projected at high speeds
in the event the tool (socket)
breaks.
Unforeseen tool movements
„ „
may result in hazardous situa-
tions.
Crushing risk based on the
„ „
torque between the counter
bearing and the work piece.
Keep hands away from the
„ „
tool (socket) being used to pre-
vent the risk of injuries.
Only use holders and adapt-
„ „
Safety instructions for air tools
ers in good condition and
intended for use with the ma-
chines described here.
Avoid an unnatural posture.
„ „
Always maintain a proper
footing and balance. This will
allow you to better control the
electrical power tool in un-
foreseen circumstances.
Switch the device off when not
„ „
in use.
Always wear personal
„ „
protective equipment and
safety glasses. Wearing
personal protective equipment
such as dust mask, non-slip
safety shoes, hard hat or ear
protectors, depending on the
type of air tool and its applica-
tion, reduces the risk of inju-
ries.
Protect hoses from kinks, con-
„ „
strictions, solvents and sharp
edges. Keep hoses away from
heat, oil and rotating parts.
Replace damaged hoses im-
„ „
mediately. A damaged supply
line may result in the air hose
flapping about, possibly result-
ing in injuries.
Do not use the equipment
„ „
when fatigued or under the
influence of drugs, alcohol or
medications. Just a moment of
carelessness when using this
equipment may result in seri-
GB/MT 51