Klarstein 10030683 Bedienungsanleitung Seite 48

EN
48
Model with touch slider (figure below):
In the timer indicator, the digits of the two-digit minute
display can be set individually. First set the units of the
minutes by sliding the slider. Touch the timer button
again. The tens digit is displayed and blinks in the
timer indicator. Now set the tens digit of the minutes by
sliding the slider.
2
Note: By continuous touching the timer button, the
minutes can be set with the slider in the following
order: "Single Digit - Ten Digit - Confirm Setting -
Single Digit - ...".
When the minute minder is set, it will begin to count
down immediately, the display will show the remaining
3
time
Buzzer will beep for 30 seconds and timer indicator
shows "- - "when the setting time is finished. Any
4
efficient touching of control buttons during it, would
end up the buzzer beeps.
2. Setting the timer to turn cooking zone off
Touch the corresponding cooking zone button on the
1
control panel for which you want to set a timer.
Touch the timer button
2
indicator is flashing.
, the number in the timer