Klarstein 10030683 Bedienungsanleitung Seite 35

Fix clips to hob:
Insert the fixing clips into fixing holes reserved on 2 sides of housing, fix clip to housing
with screw, then insert hob into cabinet/work surface.
Fix hob to cabinet:
Insert the hob into the cabinet/work surface as shown below, the mounted clips on the
sides can secure your hob sturdily.
Notes on installation
• The electric hob shall not be mounted above cooling equipment, dishwashers and
rotary dryers.
• The electric hob shall be installed such that better heat radiation can be ensured to
enhance its reliability. Therefore, keep to the specified distances and dimensions.
• The wall and induced heating zone near and above the work surface shall
withstand heat.
• To avoid any damage, the sandwich layer and adhesive must be heat resistant.
Notes on electrical connection
• The power supply should be connected in compliance with the relevant standard,
or a single-pole circuit breaker. The appliance has a large power rating and must
be connected to electricity by a qualified electrician. Do not perform the installation
yourself.
• If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3 mm between the contacts.
• The installer must ensure that the correct electrical connection has been made and
that it complies with safety regulations.
• The power cord must not be bent or compressed.
EN
35