Hama RC300 Bedienungsanleitung Seite 5

5.2 Manually setting the date/time
• Press and hold the wave button (5) for approx. 3
seconds to start manually setting the date/time
• Set the following information in the order listed:
hour, minute, year, month, day
• To select the individual values, press the + button
(2) or the – button (3) and confirm each selection
by pressing the mode button (4)
• If you do not make an entry for 30 seconds, the
settings will automatically close.
Note – Input
Hold down the + button (2) or the – button
(3) to select the values faster.
5.3 Setting the time format and day of
the week
• Press the + button (2) to switch between the 12
and 24-hour formats. In the 12-hour format, AM
or PM appears before the time.
• To set the language for the day of the week
display, press and hold the – button (3) for
approx. 3 seconds. Press and hold the – button
(3) until the language you want is shown.
Note – Day of the week
You can choose from German (GE), English
(EN), Italian (IT), Spanish (SP) and French
(FR) for the display of the day of the week.
5.4. Alarm settings and display
• Press the mode button (4) repeatedly until AL1
is displayed.
• Hold the mode button (4) for approx. 3 seconds.
The hours display begins to flash.
4
• Press the + button (2) or the – button (3) to
select the hour for the alarm time and confirm
your selection by pressing the mode button (4).
The minutes display begins to flash.
• Repeat the process to set the minutes for the
alarm time. Once you have confirmed your
minutes selection with the mode button (4),
alarm 1 is activated and
• You can also set a second alarm time.
Press the mode button (4) repeatedly until AL2
is displayed and repeat the settings for AL1.
• Press the alarm on/off button (6) to activate/
deactivate alarm time 1, alarm time 2 or both
at once. The alarm symbols
appear/not appear.
• If the alarm is triggered, the corresponding
alarm symbol will begin to flash and an alarm
will sound.
• Press the alarm on/off button (6) to stop the
alarm. Otherwise, it will stop automatically after
4 minutes.
• If you press the light / snooze button (1) during
the alarm, the alarm is interrupted for 4 minutes
and then goes off again. The corresponding
alarm symbol and the snooze symbol
will flash.
5.5. Settings and display for a second
time zone
• Press and hold the + button (2) for approx.
3 seconds to display the second time zone as
the main time. The
to the time.
• Press and hold the wave button (5) for approx.
3 seconds to set a second time in another time
zone. The hours display begins to flash.
• Press the + button (2) or the – button (3) to
make the setting and confirm your selection by
pressing the mode button (4).
appears.
and/or will
Z
Z
symbol appears next