Hama RC300 Bedienungsanleitung Seite 4

Warning - Batteries
• Immediately remove and dispose of dead
batteries from the product.
• Only use batteries (or rechargeable batteries)
that match the specified type.
• Do not mix old and new batteries or batteries
of a different type or make.
• When inserting batteries, note the correct
polarity (+ and - markings) and insert the
batteries accordingly. Failure to do so could
result in the batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/
rechargeable batteries and keep them away
from uncoated metal objects.
4. Getting Started
• Open the battery compartment (7), remove
the contact breaker and then close the battery
compartment (7).
5. Operation
5.1. Automatic date/time setting using the
DCF signal
• Once you have inserted the battery, the display
is switched on, an acoustic signal sounds and
the alarm clock automatically starts searching
for a DCF signal. During the search, the wireless
symbol will flash. This process can take 3
to 5 minutes.
• When the wireless signal is received, the date
and time are automatically set.
Display
Flashing
display
Constant
display
No display
Note
The clock automatically searches for the DCF
signal once an hour to ensure that the time
is correct. If the search fails, it ends and is
repeated at the next clock hour. The wireless
symbol will go out.
• If the station still does not receive a signal, press
the wave button (5) for approx. 3 seconds to
start the manual search for the DCF signal. The
wireless symbol
Note
The manual search takes about 3 to 5
minutes. If the search fails, it ends and is
repeated at the next clock hour. The wireless
symbol will go out.
Note – Summer time
The clock automatically switches to summer
time. S appears on the display as long as
summer time is activated.
Searching for the
DCF signal
Active
Successful – signal is
being received
Error – signal search
ended
Weak signal
reception
will start to flash.
3