Grundig GDS 2460 B Bedienungsanleitung Seite 20

Cleaning and maintenance
Anti-odor filters contain charcoal
(active carbon).
They must be changed with periods
of approximately 6 months.
Regardless of using a carbon filter
or not, aluminum filters must al-
ways be installed.
Do not operate your appliance with-
out the aluminum filter in place.
Using with carbon filter will de-
crease suction performance of the
appliance.
5.3 Cleaning
Particularly do not neglect to clean
your hood immediately after you
have made frying.
Use a soft cloth soaked with liquid
detergent to clean the outer sur-
face of your hood.
Never use abrasive or scratching
materials for cleaning.
You may use the cleaning agents
commercially available for persis-
tent grease etc. by following the
warnings on the product. In order
not the scratch the brushed steel
body, wipe in the same direction
with the bush trace.
Do not use cleaning agents con-
taining hydrochloric acid, bleach
or abrasive powders in order to
maintain the surface quality of your
product. Use a cloth dampened in
soapy water or special stainless
steel cleaning spray for stainless
steel steel surfaces. Remove the
protective foil on the appliance.
20
Caution!
• You may cause a fire if you do
not follow the instructions on the
cleaning and replacement of the
filters of your hood.
If you need to transport the appli-
ance:
• Keep the original packaging of
the appliance. Transport the ap-
pliance with its original package,
and follow the transport markings
on the original package.
If you do not have the original
package:
Do not place any objects on the
hood.
• Protect the outer surface from
impacts.
• Pack the appliance so that it would
not be damaged during transport.
5.4 Replacing the lamps
Disconnect the hood from the
mains supply.
This appliance is equipped with 3 W
halogen lamps.
To replace the halogen lamps,
press the lamp downwards from
the rear section of the lamp hold-
er to release the lamp. Then turn
it counterclockwise by 1/4 tour and
remove it.