Grundig GDS 2460 B Bedienungsanleitung Seite 14

Installing your appliance
3.2.2 Hammering the wall
plugs
Hammer Ø 10 mm wall plugs
(X,Y) into the holes drilled for
hanger screws. Hammer 2 x Ø 6
mm wall plugs (Z) into the holes
drilled with a Ø6 mm bit for the
external flue connection plate.
(Figure 5)
3.2.3 Installing the hanger
screws
Install 5.5x60 hanger screws into
the Ø 10 mm wall plugs (Y) you have
hammered into the wall. There
must be a gap of 5 mm between the
screw head and the wall. (Figure 5)
Connect the internal flue connec-
tion plate to the 6 mm wall plugs (Z)
on the wall using Ø 3.9x22 screws.
(Figure 5)
5.5 x 60 Cross-
head screw
(Figure 5)
14
X
3.9 x 22 Cross-
head screw
3.2.4 Hanging the hood onto the
wall
• Hang the hood onto the screws
you have installed into the Y holes.
• Open the side suction window
of the hood by pulling it towards
yourself. Install the 5.5x60 screws
through the X holes located inside
in order to secure the appliance.
Z
Z
Y
Y
X