Settings; Setting The Tear Position - Dascom Tally LA550 Kurzanleitung

Quick Start-en.book Seite 23 Dienstag, 22. Juni 2004 1:33 13
Quick start guide

Settings

Setting the tear position

Adjust Paprpath
Menu Char Online
1 2 3 4
Setup
TOF
Head Tear Online
1 2 3 4
Setup
TearAdj= 00/72"*
Set < > Exit Online
1 2 3 4
Setup
This section describes how to set the tear position, the first printing line, the print
head gap as well as the font selection and the character density.
If the tear position of the paper is not aligned with the tear edge of the top cover of
the printer, you can adjust it. Inserted paper needs to be torn off if necessary and
retracted to park position.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key.
Press the < (2) or > (3) key to move the perforation to the desired position. Con-
firm the input by pressing the Set (1) key.
Confirm the input again by pressing the Setup key. The printer is reset to the initial
status.
The correction made – a maximum of approx. 1" (2.5 cm) in each direction – will
be retained after switching the printer off. It can be set separately for each paper
path.
Settings
23