Final Test - Olympus CWPC-02 Bedienungsanleitung

Final test

The final test after loading the camera is explained below. This is the
only way to eliminate worry about possible entry of water! Always
perform this test. It can be performed easily in a water tank or a bathtub.
The required time is about five minutes.
Simple water immersion test Explanatory image
Place the case
1
slowly into the
water.
At first, immerse the
2
case for 3 seconds
only.
Check that no water
3
has got inside the
case.
Next, immerse the
4
case for 30
seconds.
Check that no water
5
has got inside.
Next, check by
6
immersing for 3
minutes.
7
This is the final check.
As the case is transparent, water
drops entering into it can be seen
easily.
If there is something wrong with the
waterproof packing, 3 seconds is long
enough for water to get inside. Are there
air bubbles coming out between the lids?
Please check carefully.
Remove the case from the water and
check that there is no water in the
bottom of the case.
Is there any water trickling down?
Check carefully for air bubbles!
Do not perform any operation yet,
but just observe.
Remove the case from the water and
check that there is no water in the
bottom of the case.
Be sure to check very carefully.
Check carefully for air bubbles! Try
operating the buttons used most frequently
and check carefully for air bubbles!
If there is still no water inside, everything
is OK!
Remove the case from the water
and check once more that there is
no water in the bottom of the case.
E-15
Tips